Q #41. Which of the following protocol is used for directly connected neighbor device information –
a) CDP
b) SSH
c) ICMP
d) NTP
(a) CDP (Cisco Discovery Protocol).
Q #42. Which of the following command is used to show the router routing table –
a) #show ip table
b) #show ip route
c) #show routing table
d) #show ip routing table
(b) #show ip route.
Q #43. Link State Routing Protocol uses –
a) Classfull routing protocol
b) Classless routing protocol
c) Both (a) & (b)
d) None of the above
(b) Classless Routing Protocol.
Q #44. The AD value of EIGRP –
a) 1
b) 90
c) 110
d) 120
(b) 90.
Q #45. Which of the following protocol uses Classfull routing protocol –
a) Distance Vector Protocol
b) Link State Protocol
c) Hybrid Protocol
d) None of the above
(a) Distance Vector Protocol.
Q #46. The AD value of Static route –
a) 0
b) 1
c) 90
d) 120
(b) 1.
Q #47. Which of the following is RIP Invalid timer –
a) 30 seconds
b) 40 seconds
c) 180 seconds
d) 240 seconds
(c) 180 seconds.
Q #48. OSPF was developed by –
a) IEEE
b) IETF
c) ICANN
d) IANA
(b) IETF (Internet Engineering Task Force).
Q #49. OSPF Updates are through –
a) Unicast
b) Broadcast
c) Multicast
d) Anycast
(c) Multicast.
Q #50. Which of the following table is not maintained in EIGRP –
a) Neighbor Table
b) Routing Table
c) Topology Table
d) None of the above
(d) None of the above.
—Thank You—